1. The shrinkage rate of the material molded with PEEK raw material feed is relatively small, which gives us a more reasonable control over the size of the finished material, and the production is more reasonable than other materials.
2. The stability of PEEK material is high. We are required to be more stable when using engineering plastic products. It should be because we are mainly polymer molecules. After the activation performance is improved, it is caused by curling of the chain segment. The use is still quite a lot.
3. PEEK has strong heat-resistant hydrolysis performance, which makes us have low water absorption under high temperature and high humidity environment, so it is quite stable during use.
4. PEEK is self-extinguishing, so that it can reach UL standard 94V-0 without adding any flame retardant.